Introduction Aluminium Die Casting

Die casting mould is made form steel and similar as permanent mold casting, suitable for aluminum alloy, zinc alloy and copper alloy. Now Ningbo ruican is only an aluminum die casting manufacture, not for other metal. The die cast which the melted die cast aluminum is injected into the moulds under high pressure of 10—20Mpa. The thickness of die cast part is mini 2mm, the draft angle of die cast is 0.5º. The finish of diecasting is the best in sand casting process and die casting process.

The machine is made up of two vertical platens. One platen is fixed and other is moving, can open and closed. When the melted aluminum alloy is poured into the shot sleeve, the shot sleeve will push the melted aluminum alloy into the mold cavity. After the aluminum alloy is solidified, the moving platen will be open, then the aluminum pressure die casting is removed.

The mould is the best expensive in sand casting mould and permanent mould, so the die casting process is economical only for high production.