Sand Casting Process

The Sand Casting Process

Sand casting is an economical process for creating rough metal parts. Raw castings are then machined into finished products or components. Sand casting is the least expensive of all the casting processes, including die and investment casting.
 
Forming the Cavity

In the sand casting process, a pattern is made in the shape of the desired part. The pattern is typically made of wood, plastic, or metal. A single piece or solid pattern is used for simple designs. Patterns that are more complex are made in two parts, called split patterns. The upper part of a split pattern is called a cope, while the bottom section is called a drag. Where the cope and drag separate is known as the parting line. Both solid and split patterns can have cores inserted to complete the final part shape. When making a pattern, it is necessary to taper the edges so the pattern can be removed without breaking the mold.

The pattern is housed in a box called the flask, and then packed with sand. A binder helps harden the sand into a semi-permanent shape. Once the sand mold is cured, the pattern is removed. This leaves a hollow space in the sand in the shape of the desired part. The pattern is made larger than the cast to allow for shrinkage during cooling. Sand cores can then be inserted in the mold to create holes and improve the casting’s overall shape. Simple patterns are usually open on top, allowing molten metal to be poured into them. Two-piece molds are clamped together. Molten metal is poured into a pouring cup where it will then travel down a sprue and into the gating system. Vent holes are created to allow hot gases to escape during the pour. Ideally, the pouring temperature of the molten metal is a few hundred degrees higher than the melting point, assuring good fluidity. The temperature difference also prevents premature cooling and resulting voids and porosity. After the metal cools, the sand mold is removed and the metal part is ready for additional operations, such as cutoff and grinding.

With a solid understanding of the process and its advantages, you can confidently select sand casting as the low-cost method for creating your metal components.

• 
  Aluminium Sand Casting

  Aluminum Sand Casting parts 0200

  For most of the current products, the processes we use are: sand casting (green sand & dry sand), die casting, permanent casting...
• 
  Aluminum Sand Casting

  Aluminum Sand Casting parts 0190

  We can supply aluminum and ductile iron products in permanent mold casting process, sand casting process and green sand casting...
• 
  Aluminium sand casting

  Aluminium casting